General info about digital key for Salto KS

Created by Qiang Zheng, Modified on Wed, 18 May, 2022 at 4:01 PM by Qiang Zheng

This article provides the informal knowledge about Salto KS digital key, and the features and functions regards to mobile key has been improved very fast, if you feel the info is not up to date, please reach out to support@my-clay.com and let the support know the link. Thanks!

To have mobile key for SaltoKS:

It is important to having the following requirements meet:

1. IQ2, with firmware version 10.1.4 or up, with digital key synced in Larry support

2. BLE locks with the right firmware

The minimal lock firmware supports mobile key on escutcheon

Lock firmware can be found with Salto HQ

3. digital key enabled in Larry(It is only applicable for the old migrated sites)

If a Larry support user can find the site in Larry, then press the button "Enable digital key":

Then the user should login to KS app (of course, with a completed KS profile)

After the user finished with the introduction, the user will see a digital key button, to use the mobile key, it is important for iOS (bluetooth enabled for the phone and for KS app) and for Android (bluetooth and location service enabled for the phone and for KS app)

After press the button, present the phone on the reader part on the lock, LED will flash orange (means reading), and open with green LED. This part is same as SVN

WARNING: THE INFORMATION HERE ONLY CONCERNS WITH SALTO KS DIGITAL KEY, BUT NOT WITH ACA DIGITAL KEY.